1. Place garden mount into the ground by pushing it into the ground or by using a piece of 5/16” x 3 ft. rod. Drive the rod half way into the ground. Place the garden mount over the top of the rod. (If you have the two piece mount, screw together first.)
2. Place the directional over the pole until it sets approx. 6” from the tip on the 60” one piece mount. Point the N to the North and tighten the set screw that is located between the N and E.
3. Slide the windcups onto the pole with the ball bearing side DOWN.
4. Place the design top onto the pole.

When installing on a roof, deck, post or cupola mount, install your mount to your mounting surface. Place the  short rod into the tubing of the mount. Tighten the set screw provided on the mount. Slide the directional (NSEW) over the tip of the rod. Set N to North and tighten the set screw. Place the wincups over the tip of the rod ( bearing side facing DOWN). Then slide the top on your weathevane.